Silk screen emulsion11/9/2023 ![]() ![]() If you do not have a pressure washer I would suggest looking for a small electric one to start out with, between 1000-1500 PSI, I have seen them as low as $49.95. ![]() Pressure will blow out just about any tough spot. Without the proper pressure you are going to have a hard time getting the thick spots and edges of the emulsion out. You need 1000-1500 PSI to properly blow the emulsion out after the emulsion remover has been applied to the product. All screen printing shops have a pressure washer, at least a small one. If you are using anything but(E)you are going to have a heard time blowing out the emulsion. What are you using to wash your screens out with? A. Not using enough water pressure to blow out the emulsion, applying too much emulsion originally to begin with, and not applying the emulsion remover properly. I think the majority of the problems come from these three roots. There are a couple things that can go wrong when reclaiming screens. This question is posed a lot so I am going to take some time to answer it. Thanks in advance for any help you can give me. I have another new screen that I bought the same time as the "bad" one and am wondering if I'm going to have troubles with it too. Do you have any suggestions and, can you tell me what I did wrong if anything. I first used a diluted solution of the remover and when that didn't work I tried it at full strength. ![]() I made the screens at the same time, one being the design for the front of the shirt, the other for the back. I cannot get the emulsion to wash off of the new screen. The only difference in the screens is that one is new and the other has been used many times. Hi, I was just trying to reclaim two screens. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |